Street Heat Instruction Sheets PDF Print E-mail

This kit will work on any EFI vehicle.

Street Heat Installation

THIS IS A VERY SIMPLE INSTALLATION!

Install the steel line into air duct (hose going to Carb or EFI Throttle Body).

Attach plastic line to the steel line using compression fitting.

Run plastic line back to bottle location (behind seat, truck area, etc.)

Attach plastic line to braided steel line on bottle, be sure to tighten the nut for the plastic line.

Remove braided line from solenoid and insert jet from jet card into fitting, Replace the braided line. (If you have just received your kit new in the box, this step has been done at the factory.)

Plug powerline into ashtray lighter plug.

Pull coil cord out and place in a easy location to reach.

Turn on bottle! Check for leaks!

The system is ready to go!
(DO NOT ACTIVATE THE SYSTEM WITHOUT THE MOTOR RUNNING )

Crank car and go to your local drag strip for a ride!

At wide open throttle, push the button when you want the system to run.

Turn loose of button when you want the system to cut off (Simple isn't it!)